Publicidad
Idiomas disponibles
Idiomas disponibles
Quick Start
To attach the MultiSync
follow these instructions:
.
Turn off the power to your computer.
2.
For use with the PC or MAC with DVI digital output: Connect the DVI
signal cable to the connector of the display card in your system
(Figure A.). Tighten all screws.
For a PC with Analog output: Connect the 5-pin mini D-SUB to DVI-A signal
cable to the connector of the display card in your system (Figure A.2).
For the MAC: Connect the MultiSync Macintosh cable adapter to the
computer, then attach the 5-pin mini D-SUB signal cable to the MultiSync
Macintosh cable adapter (Figure B.).
Figure A.
NOTE: Some Macintosh systems do not require a
Macintosh cable adapter.
NOTE: To obtain the MultiSync Macintosh cable adapter call
NEC Display Solutions of America, Inc. (800) 632-4662.
3.
Place hands on each side of the monitor. Tilt the LCD panel backwards to a
30-degree angle and lift up to the highest position. Connect all cables to
appropriate connectors (Figure 4).
4. To keep the cables neatly organized, place them into the cable
management system that is built into the stand.
Place the D-Sub cable and the power cable into the
specific hooks as indicated. (Figure 5).
Place the DVI cable and the 5-pin mini D-Sub to DVI-A cable into the
hooks as indicated (Figure 6).
When using the monitor in Portrait mode, place the DVI cable and the 5-pin
mini D-Sub to DVI-A cable into the hooks as indicated (Figure 7).
5.
Cables should rest flat against the stand.
LCD monitor to your system,
®
Figure A.2
3
Macintosh Adapter
(not included)
Figure B.
Publicidad
