Publicidad
Idiomas disponibles
Idiomas disponibles
Advanced OSM Controls
Tag 9
OSM ROTATION
continued
IMAGE ROTATION
PORTRAIT
WARNING
DDC/CI
SCREEN SAVER
INPUT SETTING
Tag A
TILE MATRIX
AUTO: The OSM rotates automatically when the monitor is rotated. OSM ROTA-
TION is set to AUTO by default.
MANUAL: To rotate the OSM, press the ROTATE OSM button when the OSM
is not showing.
AUTO: The display image automatically rotates according to the orientation of
the OSM. If "AUTO" is selected in the "OSM ROTATION" menu, the display
image rotates according to the orientation of the monitor.
OFF: The display image is not rotated. IMAGE ROTATION is set to OFF by
default.
ON: The display image always rotated.
When the monitor is used in the portrait position, the brightness value will be
reduced to 300 cd/m
. If the Portrait Warning is ON, a message will appear
2
on the screen for10 seconds.
DDC/CI ENABLE/DISABLE: Turns on or off the two way communication and
control of the monitor.
Use the SCREEN SAVER to reduce the risk of image persistence.
MOTION (Default OFF): Screen image moves periodically in 4 directions in
order to reduce the risk of image retention.
Timing for MOTION can be set so the screen image moves in intervals from
every 10 to 900 seconds. Timing is set in 10-second increments.
OPTION (Default REDUCED): There are two optional selections.
REDUCED: Screen image is reduced to 95% size and is moved periodically in
4 directions.
Screen may appear slightly less sharp than normal. The full image appears on
the display.
FULL: Screen image is set to FULL and is moved periodically in 4 directions.
Screen image goes outside of the display area in the direction that it shifts so
that a portion of the image may appear to be cut off.
GAMMA (Default OFF): When OFF, the GAMMA selection that the display uses
is the same as the GAMMA selection in Tag5 (page 20).
When ON is selected, the GAMMA curve (except PROGRAMMABLE) becomes
narrow, reducing the contrast and cutting down the risk of image retention.
NOTE: SCREEN SAVER does not function when the TILE MATRIX function is
enabled.
VIDEO BAND WIDTH (Analog input only): Adjusts the bandwidth of the video
signal. Can be used to eliminate undesired video noise from a poor signal.
Press "Left" or "Right" to select.
SYNC THRESHOLD (Analog input only): Adjusts the slice level of a synchroniza-
tion signal. Press "SELECT" to move the adjustment menu. Adjusts the sensitivity
of the separate or composite input signals. Try this option if the FINE adjustment
does not successfully eliminate the noise.
SOG THRESHOLD (Analog input only): Adjusts the sensitivity of the Sync On
Green input signals. Adjusts the slice level when separating a synchronization
from Sync On Green signal input. Press "Left" or "Right" to select.
EDGE LOCK: Operating your monitor at a non-standard timing may cause im-
ages to appear darker than normal or to have color distortion. Use of the Edge
Lock control will adjust images to their normal state.
The "TILE MATRIX" feature allows one image to be displayed over multiple
screens.This feature can be used with up to 25 monitors. (5 horizontal x 5
vertical) Using the Tile Matrix function requires the PC output signal to be sent
through a distribution amplifier to each of the individual monitors.
ENABLE: Select "ON", to expand the signal to the selected TILE MATRIX settings.
H MONITOR: Selects the number of horizontal displays.
V MONITOR: Selects the number of vertical displays.
MONITOR NO.: Selects a position to expand the screen.
24
– continued
Publicidad
