04 Temp.
05 Time
06 Wrinkle Prevent
07 My Cycle
08 Damp Alert
09 Drum Light
10 Adjust Time
11 Power
DV6850N_DC68-03650D-03_EN.indd 35
Press to change the temperature of the current cycle.
• High: For sturdy cottons or those labeled Tumble Dry.
• Medium: For permanent press, synthetics, lightweight cottons,
or items labeled Tumble Dry Medium.
• Med Low: For heat lower than Medium. Use to dry synthetic or
washable knit fabrics.
• Low: For heat sensitive items labeled Tumble Dry Low or
Tumble Dry Warm.
• Extra Low: Provides the lowest heated drying temperature
possible.
Press to adjust the drying time for the Manual Dry cycles. This
is not available with the Sensor Dry cycles because the dryer
determines the drying time by sensing the current moisture level
of the load.
Wrinkle Prevent provides approximately 180 minutes of
intermittent tumbling in unheated air at the end of the cycle to
reduce wrinkling. Press Wrinkle Prevent to activate this feature.
The load is dry and can be removed at any time during the
Wrinkle Prevent process.
• Press and hold Wrinkle Prevent for 3 seconds to turn off the
alarm. When the alarm is off, the Alarm Off indicator (
on.
Choose your favorite cycle including the cycle time, temperature,
and dry level. See "My Cycle" for details.
This alert is available all Sensor Dry cycles except for SANITIZE,
ACTIVE WEAR, and WOOL. Available dry levels are Normal, More,
and Extra.
If a load contains mixed fabrics, the Damp Alert indicator blinks
when average dryness of the item is 80 % dry. This lets you take
items that you don't want fully dried or that dry quickly out of
the dryer early while letting others continue to dry.
Press to turn on or off the interior lamp. The lamp stays lit for
2 minutes after it has turned on, and then turns off automatically.
You can change the set time in the Manual Dry cycles. To change
the cycle time, press the Adjust Time buttons (- and +) until the
desired time is displayed.
Press to turn on/turn off the dryer.
) turns
English 35
10/26/2018 3:16:13 PM