Parkside Performance PMFAP 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 25

Adjusting and attaching the parallel
fence
♦ Loosen the wing screw
fence .
♦ Set the desired distance.
♦ Retighten the wing screw
fence .
♦ Secure the parallel fence
fence mount using the locking screw
Routing with the parallel fence
♦ Set the parallel fence
required dimension.
♦ Place the parallel fence
of the workpiece.
Using the angle routing module
WARNING! – RISK OF INJURY!
► Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
♦ Insert the cordless multifunction router
described above.
♦ While doing so, set the desired routing depth
using the scale on the cordless multifunction
router .
♦ Release the clampinglever
setting screw to the desired routing depth.
♦ Close the clamping lever
NOTE
► Before working on the actual workpiece,
make a test cut.
♦ Loosen the locking screw
cordless multifunction router
angle.
The currently set angle can be conveniently
read using the scale on the locking screw
12
GB │ IE
■ │
on the parallel
16a
on the parallel
16a
to the parallel
.
according to the
against the edge
as
and then turn the
.
and adjust the
to the desired
.
♦ Tighten the locking screw
♦ Carry out the routing process at a uniform
speed and contact pressure.
♦ Disassembly is carried out in the reverse order.
Using the edge routing module
WARNING! – RISK OF INJURY!
► Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
► When using the edge routing module, always
make use of the extraction nozzle
♦ Insert the cordless multifunction router
described above.
♦ While doing so, set the desired routing depth
using the scale on the cordless multifunction
router .
♦ Release the clampinglever
setting screw to the desired routing depth.
♦ Close the clamping lever
NOTE
► Before working on the actual workpiece,
make a test cut.
♦ Carry out the routing process at a uniform
speed and contact pressure.
♦ Disassembly is carried out in the reverse order.
NOTE
► You can also attach the parallel fence
the back side of the edge routing module
(see the section "Adjusting and attaching the
parallel fence").
again.
.
as
and then turn the
.
on
PMFAP 20-Li A1