Velleman PIR105 Manual Del Usuario página 6

5. Operation
V. 01 – 11/12/2017
 Make sure the power supply is
disconnected.
See illustration on page 2.
Testing the Detector
1. Test the detector at the point of time
you feel the lamp needs to be switched
on.
2. Turn the TIME knob fully anticlockwise
to the minimum value (10 s). Turn the
LUX knob fully clockwise to the
maximum value.
3. Switch on the power. The detector
needs a warm-up time of ± 30 seconds
before it will switch on the connected
lamp. When no signal is detected, the
lamp will switch off after
± 10 +/- 3 seconds.
4. Turn the LUX knob fully anti-clockwise.
The lamp should switch off.
PIR105
6 ©Velleman nv