Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2609932778 04-11:BM 2609932778 04-11.qxp 3/31/11 7:40 AM Page 11
DUST
PORT
TRIGGER "ON-OFF" SWITCH
To turn the tool "ON" squeeze the trigger
switch. To turn the tool "OFF", release the
trigger switch, which is spring loaded and will
return to the "OFF" position automatically
(Fig. 1).
To increase switch life, do not turn switch on
and off while tool is under load.
"LOCK-ON" BUTTON
The "Lock-ON" button, located near the trigger
allows for continuous operation at maximum
OPM without holding the trigger (Fig. 1).
TO LOCK TRIGGER "ON": squeeze trigger,
depress button and release trigger.
TO UNLOCK THE TRIGGER: squeeze trigger
and release it without depressing the "Lock-
ON" button.
If the "Lock-ON" button is
WARNING
continuously being depressed,
the trigger can not be released.
VARIABLE SPEED WITH DIAL SETTING
Your sander is also equipped with a variable
speed dial (Fig. 1). The sander's orbital pad
speed can be preset from zero to maximum
nameplate OPM by rotating the dial in the
All manuals and user guides at all-guides.com
VAC024
BOSCH
VACUUM HOSE
SUCTION
CONTROL SLOT
Operating Instructions
housing. The dial may be set on or between
any of six positions (1=low through 6=high).
The following table may be used as a general
guide for abrasive and backing pad selection,
but the best results will be obtained by sanding
a test sample of the workpiece first.
Material
woods:
softwoods
hardwoods
veneers
metals:
steel
stainless
aluminum
rust spots
paintwork:
sanding
scratches
stripping
-11-
1-1/4"
OR
1-1/2" HOSE
Switch
Backing
Grit
setting
pad
size
rough/finish
rough/finish
4 / 6
extra soft
60 / 240
4 / 6
soft
60 / 180
4
soft
240 / 320
4
soft
60 / 240
4
soft
120 / 240
4/ 6
soft
80 / 240
6
extra soft
60 / 120
2 / 3
soft
180 / 400
4 / 6
hard
120 / 240
4
soft
40/60 /80
FIG. 9
Publicidad
