Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2609932778 04-11:BM 2609932778 04-11.qxp 3/31/11 7:40 AM Page 9
BACKING PAD DAMPER
Your tool is equipped with an integrated backing
pad damper ring. This damper reduces the
no-load speed, which helps prevent swirl
marks on the workpiece surface and provides
uniform finishing.
NOTE: If you notice steadily increasing no-
load speed, this indicates that the damper ring
is worn and needs to be replaced.
To replace damper ring, remove backing pad
as described in "Backing Pad Installation" and
remove worn damper ring by pulling firmly out
of locating groove. Align notch on damper ring
with locating tab on shroud and depress ring
with thumbs until shroud seats into groove
completely around ring (Fig. 4).
Re-attach backing pad as described in
"Backing Pad Installation"
IMPORTANT: Ring should not have bends or
ripples when correctly seated.
MICROFILTER DUST CANISTER
The integral dust extraction system collects
sanding dust in canister supplied with your
sander. For maximum efficiency, the dust
canister should be emptied frequently during
operation.
Your tool is equipped with
WARNING
a dust canister, empty it
frequently, after completion of sanding and
before storing the sander. Be extremely
careful of dust disposal, materials in fine
particle form may be explosive. Do not throw
sanding dust on an open fire. Combustion from
FIG. 5
DUST
CANISTER
All manuals and user guides at all-guides.com
FIG. 4
LOCATING
Dust Collection
mixture of varnishes, lacquers, polyurethane,
oil or water with dust particles can occur if
there is a static discharge, spark introduced in
the box, or excessive heat.
To remove dust canister: Twist the dust
canister and simply pull away from the tool
(Fig. 5).
To install dust canister: align dust port with
hole in canister and push canister onto tool
until it locks into place (Fig. 6).
FIG. 6
1
2
-9-
BACKING
PAD
NOTCH
TAB
SHROUD
REMOVING AND INSTALLING
DUST CANISTER
DUST PORT
DUST
CANISTER
DAMPER
RING
Publicidad
