When The Work Is Done - Siemens VS08 Serie Instrucciones De Uso

en
Vacuuming with accessories
12
Figure
Remove the combination tool upwards
out of the accessory holder.
a) Crevice nozzle
For vacuuming in crevices and corners.
For difficult-to-reach places, the combination tool
can be extended in two stages by pulling out the
crevice nozzle like a telescope.
Pull out the crevice nozzle in two stages until it audi-
bly clicks into place.
The crevice nozzle can be pushed back together by
releasing the telescopic locks (press in the direction
of the arrow).
b)Upholstery nozzle
For cleaning upholstered furniture, curtains, etc.
c) Hard furnishings brush
For window frames, cabinets, profiles, etc.
Fold up the upholstery nozzle in the direction of the
arrow.
The brush ring is extended by turning in the direc-
tion of the arrow.
The brush ring must be turned back in and the
upholstery nozzle folded back up before the combi-
nation tool is inserted into the accessory holder.
13*
Figure
Hard-floor brush
For vacuuming hard floor coverings (tiles, parquet floor-
ing, etc.)
Push the telescopic tube into the connecting piece of
the hard-floor brush until it engages.
Press on the unlatching sleeve and pull out the telescop-
ic tube to disconnect.
14
Figure
You can use the parking aid on the back of the vacuum
cleaner if you wish to stop vacuuming for a short time.
Slide the plastic lug on the tool connector into the
groove at the back of the vacuum cleaner.

When the work is done

15
Figure
Switch the vacuum cleaner off and unplug the power
cord from the mains.
Tug the power cord and let go. The cable then rewinds
automatically.
To reactivate or deactivate the cable brake, quickly tug
the power cord.
16
Figure
To store or transport the vacuum cleaner, use the storage
aid on the underside of the vacuum cleaner. Stand the
vacuum cleaner up on its end. Slide the plastic lug on the
floor tool into the groove on the underside of the unit.
* Dependent on model
Changing the dust bag and filters
Replacing the dust bag
17
Figure
If the dust bag change indicator lights up brightly and
evenly when the floor tool is lifted from the carpet and
the highest suction power is selected, the dust bag must
be changed, even though it may not yet be full. In this
case it is essential to change the dust bag due to the
type of material it contains.
Open the dust bag compartment lid by moving the dust
compartment locking lever in the direction of the arrow.
18
Figure
Seal the dust bag by pulling the self-seal tap and then
remove it.
19
Figure
Insert a new dust bag into the holder and close the dust
bag compartment lid.
!
Caution: the dust bag compartment lid will only close
when the disposable or textile filter are inserted.
If the dust bag change indicator is still lit after the
dust bag has been changed, please check whether
the nozzle, tube or flexible hose are blocked.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly by
knocking out the dirt and rinsing.
20
Figure
Open the dust bag compartment lid
(see Figure 17).
Pull out the motor protection filter in the direction of the
arrow.
Clean the motor protection filter by
tapping it.
If it is very dirty, the motor protection filter should be
rinsed.
The filter must then be left to dry for at least 24 hours.
After cleaning, insert the motor protection filter into the
appliance as far as it will go and close the dust bag
compartment lid.
!
Caution: The vacuum cleaner must not be operated
without the motor protection filter.
You can obtain a new motor protection filter on request as
a spare part from the after-sales service. (see Spare parts,
page 37 )
37