When The Work Is Done - Siemens VSZ3 Serie Instrucciones De Uso

4*
Figure
a) Connect the handle and the telescopic tube together.
b)Push the handle into the telescopic tube until
it engages.
Press on the locking collar and pull out the
telescopic tube to disconnect.
5*
Figure
a)Connect the floor tool and the telescopic tube
together.
b)Push the telescopic tube straight into the connecting
piece of the floor tool until it engages.
Press on the locking collar and pull out the
telescopic tube to disconnect.
6*
Figure
To adjust the length of the telescopic tube, adjust
the adjusting sleeve/sliding switch in the direction of
the arrow and adjust the tube to the required length.
7
Figure
Holding the power cord by the plug, pull out the
required length and plug it into the mains socket.
8
Figure
Press the ON/OFF button in the direction of the
arrow to switch your vacuum cleaner on/off.
Controlling the suction level
9
Figure
Adjust the suction by turning the on/off button in the
direction of the arrow.
The suction level can be infinitely adjusted to the level
required by turning the control knob in the direction of
the arrow.
Low power range
For vacuuming delicate materials, e.g. delicate
upholstery, curtains, etc.
Medium power range
For daily vacuuming of lightly soiled floors.
High power range
For vacuuming durable floor coverings, hard floors
and surfaces with heavy deposits of dirt.
Vacuuming
10
Figure
Adjusting the floor tool:
Rugs and carpets
Hard floors
Caution!
Floor tools are subject to a certain amount of wear,
depending on the type of hard floors you have
(e.g. rough, rustic tiles). Therefore, you must check
the underside of the floor tool at regular intervals.
Worn undersides of floor tools may have sharp edges
that can damage sensitive hard floors, such as parquet
or linoleum. The manufacturer does not accept any
responsibility for damage caused by worn floor tools.
32
Figure
Figure
a)Crevice nozzle for vacuuming crevices and corners,
b)Upholstery nozzle for vacuuming upholstered
Figure
Figure
Turbo brush
If your appliance is equipped with a turbo brush,
please consult the accompanying instruction manual
for notes on its use and maintenance.
Hard-floor brush
Figure
Cleaning the hard-floor brush
=>
Figure
a) Vacuum from below to clean the brushes.
b)Cut through threads and hairs wound round the
=>
=>
Figure
=>
Figure
=>

When the work is done

Figure
11
Remove the upholstery nozzle and crevice nozzle
from the accessories holder as illustrated.
12*
Vacuuming with accessories
Attach the nozzles to the suction pipe or handle as
required:
etc.
furniture, curtains, etc.
13
After use, push the crevice nozzle and upholstery
nozzle back into the accessories holder as indicated.
14*
Pet hair tool
Floor tool for easy and thorough vacuuming of pet
hair. To clean the nozzle, simply vacuum it using the
suction pipe/telescopic tube
15*
For vacuuming hard floor coverings (tiles, parquet
flooring, etc.)
16*
rollers using scissors.
Vacuum threads and hairs with the crevice nozzle.
17
You can use the parking aid on the side of the
vacuum cleaner if you wish to stop vacuuming for a
short time.
Once you have switched off the vacuum cleaner,
slide the catch on the floor tool into the groove on
the side of the appliance.
18
The appliance can also be carried using one of the
two handles, for example when vacuuming steps.
19
Unplug the vacuum cleaner.
Tug the power cord briefly and let go. The cable then
rewinds automatically.