Philips AVENT SCD525 Manual Del Usuario página 16

12 Environment
•
Do not throw away the appliance with the
normal household waste at the end of its life,
but hand it in at an official collection point for
recycling. By doing this, you help to preserve
the environment (Fig. 34).
•
Rechargeable and non-rechargeable
batteries contain substances that may
pollute the environment. Do not throw
away rechargeable and non-rechargeable
batteries with the normal household waste,
but hand them in at an official collection
point. Always remove rechargeable and non-
rechargeable batteries before you discard and
hand in the appliance at an official collection
point. (Fig. 35)
13 Guarantee and
service
If you need service or information or if you have a
problem, please visit the Philips AVENT website at
www.philips.com/welcome or contact the Philips
Consumer Care Centre in your country. You find
its phone number in the worldwide guarantee
leaflet. If there is no Consumer Care Centre in
your country, go to your local Philips dealer.
16
All manuals and user guides at all-guides.com
14 Frequently asked
questions
This chapter lists the questions most frequently
asked about the appliance. If you cannot find the
answer to your question, contact the Customer
Care Centre in your country.
What is ECO mode? How does this mode help
the environment?
• The ECO mode has been developed to enable
you to reduce your energy consumption.
Monitoring your baby from a small distance
requires less power than monitoring your baby
from a large distance. When you monitor your
baby from a small distance, you can activate the
ECO mode. By switching on the ECO mode,
your baby monitor uses less energy and is
therefore more enviornment-friendly.
Why don't the power-on light of the baby unit
and the LINK light of the parent unit come on
when I press the on/off buttons of the units?
• Perhaps the batteries of the parent unit are
empty and the parent unit is not in the plugged-
in charger. Insert the small appliance plug into
the charger, put the adapter of the charger
in a wall socket and place the parent unit in
the charger. Then press the on/off button to
establish connection with the baby unit.
• Perhaps the non-rechargeable batteries of the
baby unit are empty and the baby unit is not
connected to the mains. Replace the non-
rechargeable batteries or connect the baby unit
to the mains. Then press the on/off button to
establish connection with the parent unit.
• If the LINK light on the parent unit still does not
start to flash, use the reset function to reset the
units to their default settings.