Errors And Faults - Trotec TTK 75 E Manual De Instrucciones

Ocultar thumbs Ver también para TTK 75 E:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 78

Errors and faults

The accurate functionality of the device was tested
during production a number of times. However, if
functionality faults do occur, then check the device
according to the following list.
The device does not start:
• Check the mains power
(230 V/1~/50 Hz).
• Check the mains plug for damages.
• Have the electrics checked by a specialist compa-
ny
for
cooling
®
by TROTEC
.
The device runs but forms no condensation:
• Check the condensation tank is positioned correct-
ly. Check the fill level of the condensation tank and
empty it if necessary. The condensation tank indi-
cator light must not light up.
• Check the float in the condensation tank for dam-
ages. If necessary, clean the float and condensa-
tion tank. The float must be able to move freely.
• Check the room temperature. Ensure that the de-
vice's operating range complies with the technical
data.
• Ensure that the relative humidity complies with the
technical data.
• Check that the selected humidity is realistic. The
humidity in the room must be above the selected
range. Reduce the preselected relative humidity by
turning the rotary switch (12), if necessary.
• Check the air filter is not dirty. If necessary, clean
or replace the air filter.
EN
and
air-conditioning
Operating Manual – Dehumidifier TTK 75 E
• From the outside, check the condenser for dirt (see
chapter Maintenance). If your condenser is dirty,
have it cleaned by a specialist company for cooling
and air-conditioning or by TROTEC
The device is loud or vibrates; condensation leaks:
• Check whether the device is standing upright and
on an even surface.
The device gets very warm, is loud or is losing
performance:
• Check the air inlets and air filter are not dirty. Re-
move external dirt.
or
• Check the inside of the device and especially the
fan, the fan housing, the evaporator and the con-
denser for external dirt (see chapter Maintenance).
If the inside of the device is dirty, have it cleaned
by a specialist company for cooling and air-condi-
tioning or by TROTEC
Does your device still not operate correctly after
these checks?
Bring the device to a specialist company for cooling
and air-conditioning or to TROTEC
®
.
®
.
®
for repairs.
B - 9

Publicidad

Tabla de contenido
loading

Tabla de contenido