Publicidad
Idiomas disponibles
Idiomas disponibles
Rip fence (Guide rule)
Optional accessory
The handy rip fence allows you to do extra-accurate
straight cuts. Simply slide the rip fence up snugly
against the side of the workpiece and secure it in posi-
tion with the clamping screw on the front of the base. It
also makes repeated cuts of uniform width possible.
2
► 1. Rip fence (Guide rule) 2. Clamping screw
Lanyard (tether strap) connection
Safety warnings specific for use at height
Read all safety warnings and instructions. Failure
to follow the warnings and instructions may result in
serious injury.
1.
Always keep the tool tethered when working
"at height". Maximum lanyard length is 2 m
(6.5 ft).
The maximum permissible fall height for lan-
yard (tether strap) must not exceed 2 m (6.5 ft).
2.
Use only with lanyards appropriate for this tool
type and rated for at least 7.0 kg (15.4 lbs).
3.
Do not anchor the tool lanyard to anything on
your body or on movable components. Anchor
the tool lanyard to a rigid structure that can
withstand the forces of a dropped tool.
4.
Make sure the lanyard is properly secured at
each end prior to use.
5.
Inspect the tool and lanyard before each use
for damage and proper function (including
fabric and stitching). Do not use if damaged or
not functioning properly.
6.
Do not wrap lanyards around or allow them to
come in contact with sharp or rough edges.
7.
8.
9.
10. Do not carry the tool by the attachment device
11.
12. Do not attach lanyards to the tool in a way that
13. Avoid getting tangled in the lanyard.
14. Keep lanyard away from the cutting area of the tool.
15. Use multi-action and screw gate type cara-
16. In the event the tool is dropped, it must be
1
► 1. Hole for lanyard (tether strap)
MAINTENANCE
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
guards to ensure there is no accumulated saw-
dust which may impede the operation of the lower
guarding system. A dirty guarding system may limit
the proper operation which could result in serious
personal injury. The most effective way to accomplish
this cleaning is with compressed air. If the dust is
being blown out of the guards, be sure the proper
eye and breathing protection is used.
dust on the tool. Fine saw dust may come inside the
tool and cause malfunction or a fire.
13 ENGLISH
Fasten the other end of the lanyard outside
the working area so that a falling tool is held
securely.
Attach the lanyard so that the tool will move
away from the operator if it falls. Dropped tools
will swing on the lanyard, which could cause injury
or loss of balance.
Do not use near moving parts or running
machinery. Failure to do so may result in a crush
or entanglement hazard.
or the lanyard.
Only transfer the tool between your hands
while you are properly balanced.
keeps guards, switches or lock-offs from oper-
ating properly.
bineers. Do not use single action spring clip
carabineers.
tagged and removed from service, and should
be inspected by a Makita Factory or Authorized
Service Center.
CAUTION:
Always be sure that the tool is
CAUTION:
Clean out the upper and lower
CAUTION:
After each use, wipe off the saw
1
Publicidad
