Troubleshooting Tips - POLTI Forzaspira LECOLOGICO AQUA ALLERGY_NATURAL CARE Manual De Instrucciones

REPLACEMENT
CONTROL BATTERIES
only for Forzaspira Lecologico Aqua Allergy
_Turbo Care model
THE PRODUCT IS NOT SUPPLIED WITH
BATTERIES.
In order to work, the remote control handle
needs to be powered by two 1.5V AAA
batteries. The battery life depends on the
frequency of use. If the vacuum cleaner does
not respond to the remote control, replace
the batteries.. Take the remote control handle,
press the lever on the battery cover (23),
pulling it towards
keypad.Remove the small cover and replace
the batteries taking care to match up the +
and – signs with those indicated. Replace the
cover (23).
TROUBLESHOOTING - TIPS
PROBLEM
The vacuum cleaner does
not start.
The vacuum cleaner
switches off during suc-
tion and the four indicator
lights flash.
The suction power de-
creases.
Water leaks during suc-
tion of liquids.
Should the problems persist, contact an Authorised Polti Service Centre (see
www.polti.com for the up-to-date list) or Customer Services.
OF REMOTE
the remote control's
CAUSE
Lack of voltage.
The remote control bat-
teries are flat (only for
models that provide it).
The liquid level in the
container is too high.
The selected power is
too high for the type of
surface.
The nozzle, hose or ac-
cesories may be blocked
up, or the Hepa filter
may be dirty.
The float is obstructed.
SOLUTION
Check cable, plug and socket.
Replace the batteries as indicated
in the section "Replacing remote
control batteries".
In both cases, press the main
switch (1), unplug the power cable
and leave it unplugged for a few
seconds in order to reset the
safety device.
Clean the Hepa filter and remove
any obstructions from the hose.
Clean the filter assembly and make
sure that the water level in the
container is correct.
| 25 |