Publicidad
Idiomas disponibles
Idiomas disponibles
4
LED DISPLAY
REVERSED (red) LED flashing: The connections are reversed.
CHARGING (yellow/orange) LED lit: The charger is charging the battery.
CHARGING (yellow/orange) LED flashing: The charger is in abort mode.
CHARGED (green) LED pulsing: The battery is fully charged and the
charger is in maintain mode.
NOTE: See the Operating Instructions section for a complete description of
the charger modes.
GROUNDING AND AC POWER CORD CONNECTIONS
This battery charger is for use on a nominal 120 volt circuit. The plug must be
plugged into an outlet that is properly installed and grounded in accordance with
all local codes and ordinances. The plug pins must fit the receptacle (outlet). Do
not use with an ungrounded system. NOTE: Pursuant to Canadian Regulations,
use of an adapter plug is not allowed in Canada. Use of an adapter plug in the
United States is not recommended and should not be used.
USING AN EXTENSION CORD
The use of an extension cord is not recommended. If you must use an
extension cord, follow these guidelines:
• Pins on plug of extension cord must be the same number, size, and shape as
those of plug on charger.
• Ensure that the extension cord is properly wired and in good electrical condition.
• Wire size must be large enough for the AC ampere rating of charger, as
specified below:
Length of cord (feet):
AWG* size of cord:
*AWG-American Wire Gauge
All manuals and user guides at all-guides.com
FEATURES/CONTROL PANEL
2
1
3
25
50
18
18
• 6 •
1. Ring connectors (quick-connect)
2. 12V Accessory plug (quick-connect)
3. Battery status LEDs
4. Battery clamps (quick-connect)
100
150
16
16
Publicidad
