Tristar SZ-1911 Manual De Usuario página 5

Operation and maintenance
Remove all packaging of the device.
Check if the voltage of the appliance corresponds to the main voltage of your home.
Rated voltage : AC220-240V 50Hz.
This vacuum is not designed to collect liquids and sharp items. Never vacuum hot ashes,
make sure it is fully cooled.
First use
Place the hose (with the side of the hose coupling) in front of the vacuum, if you hear a click,
this just confirmed. Place the vacuum foot on the telescope tube, the telescope tube length can
be made, according to your wishes, by pressing the button down and push the tube to extend
or reduce. The maximum length setting of the tube is 94 cm. To disconnect the hose press the
button of the hose coupling. Use the button on the vacuum foot to the desired position, with or
without a brush on the bottom of the suction foot.
Always make sure that all the filters and the dust bag are correctly fitted before using the
appliance. Damaged or incorrectly fitted filters or dust bag may cause damage to the appliance.
Use
Pull the power cord totally from the vacuum cleaner and place it into a wall outlet. Press the
on/off switch (no. 4) to start your vacuum cleaner.
The suction power regulator (no.5) controls the suction if it should be temporarily reduced.
To turn the unit off, press the on/off switch. Unplug the power cord and press the cable rewind
button (no. 6). You can use the storage clip at the back of the device to store the vacuum bar
when you store the vacuum cleaner.
Cleaning and maintenance of the device
Always remove the plug from the outlet when the device is not used, the filters are cleaned or
the dust bag will be replaced.
Replace of the dust bag.
You need to replace the dust bag when the dust bag full indicator (no 3) lights.
Do this immediately otherwise it loses much suction power.
Disconnect the hose from the hose connection (no 2).
Open the unit by pressing the handle for opening dust
bag compartment (no 1). The valve is open, see step 1
in the drawing
in the drawing. Pull the bag up from the dust bag
holder, see step 3 in the drawing. Place a new bag in
the holder and press it down. Close the lid of the
compartment and torque the hose to the hose
connection.
All manuals and user guides at all-guides.com
UK
Turn up the dust bag holder, see step 2
.
9
Cleaning of the filters.
To ensure the best suction of the vacuum cleaner, you should clean the filters at the top (the
exhaust filter) and behind the bag (inlet filter) regularly.
Cleaning the inlet-filter
Disconnect the hose from the hose connection (no 2). Open the unit by pressing the handle for
opening dust bag compartment (no 1). The valve is open. Turn up the dust bag holder. Pull the
bag up from the dust bag holder. Remove the filter from the
filter holder. Clean the filter with warm water, let the filter dry
completely before replacing it. The filter is not dishwasher
safe.
Cleaning of the exhaust filter
Disconnect the hose from the hose connection (no 2). Open the unit by pressing the handle for
opening dust bag compartment (no 1). The valve is open. Turn up the dust bag holder. Pull the
bag up from the dust bag holder and remove the filter house. Clean the filterhouse with warm
water, let the filter dry completely before replacing it. The filter is not dishwasher safe.
The vacuum cleaner and the other parts you can use a damp cloth to decline.
Never immerse the device in water or other liquid.
Never use the vacuum with a wet filter! This may cause an electric shock and
the unit may malfunction.
10