Publicidad
Idiomas disponibles
Idiomas disponibles
Remove exterior and interior packings, wipe the outside thoroughly with a soft dry cloth and the inside with a
wet, lukewarm cloth. Avoid placing the unit in a narrow recess or near any heat source, direct sunlight, or
moisture. Let air circulate freely around the unit. Keep the rear of the refrigerator 5 inches away from the
wall.
Location
1) Select a place with a strong, level floor.
2) Allow 5 inches of space between the back of the refrigerator and any adjacent wall.
3) Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
4) Avoid very moist places. Too much moisture in the air will cause frost to form very quickly on the evapora-
tor, and your refrigerator will have to be defrosted more frequently.
1) THERMOSTAT DIAL
2) TEMPERED GLASS SHELVES
3) MAGNETIC GASKET: Tight fitting door seal
keeps all the cooling power locked inside. No hooks or
latches.
4) CRISPER WITH TEMPERED GLASS SHELF
5) 2 LITRE AND GALLON BOTTLE STORAGE
To avoid vibration, the unit must be set level. This is accomplished by adjusting the (2) front leveling legs
located under the refrigerator. To start the refrigerator, turn the temperature control to the position
corresponding to the desired cooling. We recommend starting the temperature at 4 (middle setting) and
adjusting if necessary.
OFF = No Cooling
1 = M inimum Cooling
The temperature will vary depending on the quantity of the food stored and on the frequency with which the
door is opened.
INSTALLATION INSTRUCTIONS
FEATURES
OPERATING INSTRUCTIONS
4 = Medium Cooling
MAX = Maximum Cooling
2
4
2
1
3
5
Publicidad
