Publicidad
Idiomas disponibles
Idiomas disponibles
( 4 )
Fridge / Power Cool (3 sec)
The Fridge button serves two purposes:
-
To set the Fridge to your desired temperature.
-
To turn the Power Cool function on and off.
1. To set the Fridge temperature, press the
Fridge button.
You can set the temperature between 44 °F
(7 °C) and 34 °F (1 °C).
2. Power Cool function
Touch and hold this button for 3 seconds to
decrease the time needed to cool products in
the Refrigerator.
It can be helpful if you need to quickly cool
easily spoiled items or if the temperature in the
fridge has warmed dramatically.
(for example, if the door was left open)
( 5 )
Lighting / °C↔°F (3sec)
The Lighting button serves two purposes:
-
To turn the dispenser light on and off
-
To switch the temperature units between ºC
and ºF.
1. Light Function
Touching the Lighting button turns on the
Dispenser LED lamp in continuous mode so that
it stays on continuously.
The button also lights up.
If you want the Dispenser lamp to come on only
when some one uses the dispenser, press the
Lighting button to turn the continuous mode off.
2. To switch the temperature units between ºC
and ºF.
Touch and hold this button for 3 seconds to
select the temperature display you want.
Each time you press and hold the button, the ºC
and ºF temperature modes alternate and the ºC
or ºF icon lights up, indicating your selection.
DA68-02601D-05.indb 19
( 6 )
Ice Maker Off
If you don't want to make more ice, touch the
Ice Maker Off button.
The icon will light up and the Ice-Maker stops
making ice.
We recommend you to stop ice making if the
following occur:
-
There is enough ice in the ice bucket.
-
You want to save water and energy.
-
Water is not being supplied to the refrigerator.
If the ice maker function is ON, and the water
Line is not connected, there will be a water valve
noise from the back of the unit. Press the Ice
Maker Off (Control Lock (3sec)) button for less
than 3 seconds until the Ice Off Indicator (
illuminates.
( 7 )
Water
Touch this button to dispense water.
This mode can not be used with the Ice Type
mode simultaneously.
Water mode shuts off when you touch the
Cubed / Crushed Ice button.
To save electricity, the Panel Display turns off
automatically under the following conditions:
When no button has been pressed, when no
doors are open, or when no Dispenser Lever
has been pushed.
However, the icon indicating your cubed or
crushed ice selection, will stay on.
When you press a button, open a door, or push
a Dispenser Lever, the Panel Display will turn
on again.
Except for the Energy Saver, Water, and Cubed
/ Crushed Ice buttons, all function buttons
will become operational after you remove
your finger from the button you are currently
pressing.
English - 19
)
2020. 7. 24. 오후 5:41
Publicidad
