Publicidad
Idiomas disponibles
Idiomas disponibles
2 - DESC RIPTI ON O F TH E AP PL I AN CE
1
2
4 5
3
1.
Front grill
2.
Blade nut
3.
Fan blades
4.
Rear grill Screws (4)
5.
Rear grill
6.
Motor housing screw
7
8
6
9
10
11
7.
Motor housing
8.
Height adjustment thread
9.
Column
10. Base Legs (4)
11. Base
ENGLISH-3
3 - AS S EMBLY
All instructions and recommendations in this manual must be followed to ensure the proper assembly.
Failure to follow the assembly instructions may cause the product to malfunction and it could forfeit
the warranty.
The proper assembly will ensure good product performance and prevent damages to the product,
accidents and/or injuries.
In order to use your fan, it is necessary to assemble it.
You will need an screwdriver to assemble the unit.
[01] Position the motor housing on a flat and sturdy surface. Attach the rear grill and secure it using
the rear grill attaching nut.
[02] Insert the fan blade and then attach it with the blade nut. Hold the nut and turn the fan blade
clockwise.
Attention! When assembling the fan blade, make sure it is in the right position and that the
blade nut is secure and tight. If the fan blade is not mounted in the right position, it may
scrape on the front or rear grill or be out of balance thus generating vibration.
[03] Place the front grill. Please note that the front grill has a series of latches to secure and guarantee
it attaches properly to the rear grill.
[Figure 1]
[Figure 3]
[04] Position the column on the base and secure the assembly to the bottom of the base to the base
with the 4 screws and 4 nuts.
[05] Remove the height adjustment thread and insert the base cover through the top of the column.
[06] Turn the height adjustment screw to position the column to the desired height.
ENGLISH-4
[Figure 2]
[Figure 4]
Publicidad
