Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Replace with the Natural gas orifice.
IMPORTANT: Check that the NG orifice is properly
installed inside of the valve.
5.
Reinstall the sear burner. Make sure the sear burner tube
is inserted into the gas valve, as shown.
6.
Reinstall the two screws to the rear of the searing burner.
7.
Use a screwdriver to reinstall the igniter pin.
8.
Open the manual shutoff valve in the gas supply. The
valve is open when the handle is parallel to the gas pipe.
A.
B.
9.
Test all connections using an approved non-corrosive
leak-detection solution. Bubbles will show a leak. Correct
any leak found
43
Closed valve
Open valve
Publicidad
