collaxx Colour Light Unit Manual De Instrucciones página 7

Synchronisation
Every remote control has been assigned a serial number. The
lamp must be synchronized with the remote control before
it responds to the remote control commands. This is done
by the manufacturer. To perform the synchronization
yourself, please proceed as follows:
1. Unplug the lamp
2. Wait for at least 10 seconds
3. Plug in the lamp again
4. Press the | button on the remote control within 10
seconds after you have plugged in the lamp
By performing the above synchronization procedure, you can
also operate several lamps at the same time using only one
remote control.
Automatic mode programming
The factory setting of the colour change interval in automatic
mode is 5 minutes. You can change this interval as many
times as you wish by proceeding as follows:
1. Press the automatic button ~ and hold until the yellow
light switches on (for approximately 10 seconds)
2. The programming mode is now active. Leave the yellow
light on for the desired interval (10 seconds up to 4
hours).
3. Then press the automatic button ~ to change the
colour. The time that has elapsed since the activation of
the programming mode is saved. It is the new automatic
interval for all colours.
Status memory
The lamp has a status memory. When the light unit is
switched on, the same status that was active at the time
when it was switched off will be activated. The status
memory also works if you switch off the lamp by interrupting
the power supply to the lamp. If automatic mode was active,
it always starts with red.
Troubleshooting
If your lamp does not respond to the remote control
commands, check at first whether the power supply is ok.
Then perform a synchronisation.
The battery is designed for 28 years standby respectively 10
million button activations. Therefore, the possibility that the
fault has been caused by an empty battery can be ruled out
safely.
Never try to repair a faulty lamp! Always send it back to the
manufacturer with all accessories (power supply unit, remote
control). Please enclose a description of the error.
Please find the manufacturer's contact details at
www.collaxx.com.
Warranty
The statutory warranty applies from the date of the invoice.
Therefore, please always ensure that you keep your receipt
safe.
Your warranty claims are null and void if you open the housing
of the diode or the remote control or if you subject the
components to an excessive ambient temperature (over
125°C).
Use only the supplied power supply unit to supply power to
the lamp.
EN
7