Cleaning And Maintenance; Battery Replacement And Charging - cecotec CONGA 1690 Manual De Instrucciones

ENGLISH

7. CLEANING AND MAINTENANCE

Main brush and silicone brush
1. Turn the robot around and press the main brush's release button to take the cover out.
2. Take the main brush out and clean the compartment.
3. Clean the main brush with the provided tools and use water and soap if necessary.
4. Place the main brush in its position and fasten the cover's clip.
Recommendation: Replace the main brush every 6-12 months to ensure efficient operating
(depending on the frequency and type of use).
Fig. 28
5. Main brush cover
6. Tab
7. Main brush
8. Compartment
Dust tank
Open the robot's cover and take out the dust tank.
Open the dust tank, take the high-efficiency filter out and empty the dust.
Clean high-efficiency filter with the cleaning brush.
Introduce the dust tank back into the robot and close the top cover.
Fig. 29
High-efficiency filter
Remove the high-efficiency filter and shake it to remove all the dust.
Recommendations:
Replace the high-efficiency filter every 3 months depending on the frequency and type of use.
Clean the filter periodically with a brush to avoid blockage.
Side brushes
Fig. 30
Remove and clean the side brushes regularly.
Recommendation: In order to ensure a perfect cleaning, it is suggested to replace the side
brushes every 3 months, depending on the frequency and type of use.
Free-fall sensors
Fig. 31
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned off and in its original package.
38

8. BATTERY REPLACEMENT AND CHARGING

Do not use any other battery, power adapter or charging base than the one officially provided
by Cecotec.
Do not use non-rechargeable batteries.
Do not remove, dismantle or attempt to repair the battery or the charging base.
Do not place the charging base near heat sources.
Do not use a wet cloth to wipe any of the parts of this product.
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place. It is suggested to charge the battery every month in order to
avoid damage to the battery.
Do not dispose of waste batteries at will. It is suggested to hand them over to professional
organizations for correct treatment.
9. TROUBLESHOOTING
Problem
The robot does not start up or does not
clean.
The robot cannot charge or return to the
charging base.
ENGLISH
Solution
The robot cannot operate when the battery is
low. Allow it to charge before operating it.
The room temperature is below 0 ºC or above
50 ºC. Operate the robot in a room where
the temperature is between the stated
temperature range.
There are too many obstacles near the
charging base, relocate the charging base to
an area free of obstacles.
Clean the charging terminals.
Make sure the power switch is turned on.
The robot is too far away from the charging
base, place it closer and try again.
There is very little free space around the
charging base. Make sure the charging
terminals are clean.
39