Power Supply - Monacor ATS-10R Manual De Instrucciones

4 Power Supply

The receiver is supplied with power via the two sup-
plied rechargeable NiMH batteries. Instead of the
rechargeable batteries it is also possible to use two
non-rechargeable 1.5 V batteries of size AA.
1) Slightly press the grooves on the battery compart-
ment cover (11) while pulling the cover downwards
at the same time.
2) Insert the batteries with the positive and negative
connections as printed in the compartment.
3) Replace the cover and make sure it engages.
Never put batteries in the household
waste; always take them to a special waste
disposal, e. g. collection container at your
retailer.
Hint: For quick and easy charging of the rechargeable bat-
teries used in ATS-10R and ATS-10TM, MONACOR offers
special chargers:
– charging station ATS-10PS for charging the batteries of
up to 2 units at the same time
– charging case ATS-12C for charging the batteries of up
to 12 units at the same time
– charging case ATS-30C for charging the batteries of up
to 30 units at the same time
5 Operation
1) Screw the supplied antenna (1) into the threaded
jack ANT. (5).
2) The sound can be reproduced via the integrated
speaker (4) or via the supplied earphone. When
using the earphone, connect it to the jack EAR. (6)
[the speaker is switched off in this case] and attach
the earphone to your ear.
3) Use a narrow object (e. g. screwdriver) to set the
channel selector switch CHANNEL SELECT (9) to
the same position as the channel selector switch
on the transmitter.
4) Use the clip (10) to fasten the receiver to your
clothes, e. g. belt.
5) Switch on the transmitter.
6) To switch on the receiver, set the switch (7) to the
left stop to ON. (In the mid-position STAND BY, the
receiver is also switched on but it is mute, i. e. no
sound is reproduced via the speaker or earphone.)
After switching on, the LED BATT. LOW (8) brief-
ly flashes red before permanently showing green.
(If the LED shows a dim green light only, no radio
signal is received, i. e. the transmitter is switched
off or set to a different channel than the receiver.)
If the LED permanently shows red, the (rechargea-
ble) batteries are almost discharged and must be
recharged or replaced.
7) After the volume for the audio signal has been ad-
justed on the transmitter, adjust the desired repro-
duction volume with the control VOL (2).
8) To switch off the receiver, set the switch (7) to the
right stop to OFF: The LED BATT. LOW (8) briefly
flashes red before it is extinguished.
9) In case of problems caused by interference or poor
reception, see the corresponding notes in the in-
struction manual of the transmitter.
6 Specifications
Type of unit: . . . . . . . . 16-channel PLL receiver for
Radio frequency range: 863 – 865 MHz
Ambient temperature:. 0 – 40 °C
Power supply: . . . . . . . 2 × rechargeable 1.2 V NiMH
Dimensions : . . . . . . . . . 65 × 92 × 25 mm (W × H × D)
Weight: . . . . . . . . . . . . 80 g (without batteries)
Subject to technical modification.
All rights reserved by MONACOR
Co. KG. No part of this instruction manual may be reproduced
in any form or by any means for any commercial use.
wireless audio transmission
battery or 2 × 1.5 V battery,
size AA
INTERNATIONAL GmbH &
®
7