Rockford Fosgate POWER T1000-4 Instalación Y Funcionamiento página 12

T
ROUBLESHOOTING
2. Bypass any and all electrical components between the stereo and the amplifier(s). Connect stereo
directly to input of amplifier. If noise goes away the unit being bypassed is the cause of the noise.
OR
3. Remove existing ground wires for all electrical components. Reground wires to different locations.
Verify that grounding location is clean, shiny metal free of paint, rust etc.
OR
4. Add secondary ground cable from negative battery terminal to the chassis metal or engine block of
vehicle.
OR
5. Have alternator and battery load tested by your mechanic.Verify good working order of vehicle
electrical system including distributor, spark plugs, spark plug wires, voltage regulator etc.
S
PECIFICATIONS
MODEL- POWER
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Per Channel
2 Load Per Channel
4 Load Bridged
2 Load Bridged
Dimensions: Height
Width
Length
Battery Fuse Rating (Amp) External (Not Supplied)
"A" Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms
"A" Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms
Crossover Slope
Crossover Frequency
Frequency Response
Signal Voltage Adjustment Range
Protection
Equalization PEQ (Punch Equalization)
Input Impedance
Operating Voltage
Balanced Inputs (Front and Rear)
CMRR (Common Mode Rejection Ratio)
Damping Factor
THD+N (Total Harmonic Distortion + Noise)
These specifications are Amplifier Power Standard CEA-2006 Compliant
12
All manuals and user guides at all-guides.com
protection circuitry limits power in case of overload,
plus short protection. Thermal switch shuts down
Specifications subject to change without notice
T1000-4
150 Watts x 4
250 Watts x 4
500 Watts x 2
STABLE
(reduced thermal time may occur)
2.14" (5.44cm)
8.14" (20.68cm)
21.875" (55.66cm)
200A
≥85 dB
≥105 dB
24dB/octave Butterworth
variable from 50Hz to 500Hz
20Hz to 20kHz ±1dB
Variable from 150mV to 5V (RCA Input)
NOMAD - Internal analog-computer output
the amplifier in case of overheating.
Variable from 0dB to +18dB @ 45Hz and/or
0dB to +12dB @ 12KHz
20K ohms
9 to 15.5 Volts DC
Yes
>55dB @ 1KHz
>200
< 0.5% @ 2 ohm and < 0.1% @ 4 ohm