GYS EASYCUT 25/40 Manual De Instrucciones página 18

SAFETY TRIGGER
The torch is equipped with a safety latch to prevent accidental use: Unlock it and pull the trigger as below:
1
Wear appropriate protective equipment. Stay away from the tip of the torch. Keep your hands away from the cutting trajectory. Never
point the torch towards you or another person.
TIPS FOR CUTTING
• Lightly drag the tip on the part for an even cut. This will guarantee a constant, adapted distance.
• When cutting, ensure that the sparks come from the bottom of the part . The sparks should lag slightly behind the torch when cutting (angle of
15 ° to 30 ° from the vertical).
• If the sparks fly from the top of the part, slow the movement, or set the output current to a higher level.
• For straight cuts, use a ruler as a guide.
MANUAL CUT FROM THE EDGE OF THE PART
With the earth clamp is fastened to the part, maintain the torch's tip perpendicu-
1
larly (90°) to the edge of the part.
Press the torch's trigger to start the arc until this one has completely cut into the
2
part.
Once the part is cut, slightly drag the tip on the part to continue the cut. Try to
3
maintain a regular rythmn.
18
EASYCUT
2 3
EN