Mounting Of Protector - Makita EM2650UH Manual De Instrucciones

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/
protector combinations as indicated in the table must be used.
For EM2650UH
– In use of the metal blade, fix the protector (3) to the clamp (2) with two bolts
M6 x 30 (1).
NOTE: Tighten the right and left bolts evenly so that the gap between the clamp
(2) and the protector (3) will be constant.
Otherwise, the protector sometimes may not function as specified.
– In cases where the nylon cord cutter is to be used, be sure to mount the
protector extension (4) onto the metal blade protector (3).
– Mount the protector extension (4) by sliding it into place from the flank of the
metal blade protector (3) as shown.
– Remove tape adhered to cutter, which cuts nylon cord, on protector extension
(4).
CAUTION: Be sure to push in protector extension (4) until it is fully inserted.
Take care not to injure yourself on the cutter for cutting the nylon
cord.
– To remove the protector extension (4), apply a hex wrench into the notch on
the metal blade protector (3), push it in and meanwhile slide the protector
extension (4).
For EM2650LH, EM2652LHN
– Fix the protector (3) to the clamp (2) with two bolts M6 x 30 (1).
NOTE: Tighten the right and left bolts evenly so that the gap between the clamp
(2) and the protector (3) will be constant.
Otherwise, the protector sometimes may not function as specified.
(3)
(4)
(1)
10
(2)
(1)
(3)
Hex wrench
(3)
(2)