Makita EM2650UH Manual De Instrucciones página 17

Replacing the nylon cord
– First, stop the engine.
– Hold the housing securely and turn the spool clockwise until the remaining
nylon cord retracts into the housing, and turn back and forth to relieve the
cord stress.
– Grasp the loop on top of the spool and pull it from the spool.
– Prepare a nylon cord with the following specifications.
4.5 m (15 ft) length
2.4 mm (0.095") diameter round cord or 2.0 mm (0.08") diagonal square cord.
– Align the arrow on the spool with the eyelets on the housing.
– Insert one end of the nylon cord into eyelet on the side of the housing, feed
through hole on top of the spool and then re-insert into the second hole on
top of the spool. Push the nylon cord into holes until the cord feeds through
eyelets on side of the housing.
– Push the nylon cord into holes feeding through eyelets on side of the housing
until equal length on both sides.
– Hold the housing securely and turn the spool clockwise to wind the nylon cord
into the spool.
17