Descargar Imprimir esta página

Truper ESMA-4580N Manual página 8

Ocultar thumbs Ver también para ESMA-4580N:

Publicidad

Auxiliary handle assembly
CAUTION
Before performing any operation,
always make sure that the auxiliary handle is firmly
installed. Set the auxiliary handle in one of the three
positions according to the operator's preference and
the job to perform.
The angle grinder is a manual power tool used to grind and cut steel, pipes, iron angles, brick, tile, stone and / or ceramic
pieces; to remove burr on metal surfaces, to level and make smooth welding lines. If the tool accessory is changed it can be
used to remove oxide and to polish metal surfaces and other materials.
Switch On
Intermittent operation
• Connect the plug.
• Slide the switch forward by applying pressure only in the back side.
When the pressure is reduced, the switch returnsto its original position.
Continuous operation
• Connect the plug.
• Slide the switch to the front of the tool and press down the front of the switch.
To interrupt operation, press the back of the switch and release it.
How to correctly hold the tool
Always hold the tool with both hands. Hold the
handle with one hand and the other hand hold the
auxiliary handle. Be careful not to obstruct the
ventilation slots.
• Grinding:
For better results hold the tool 15° to 30° regarding
the work piece. Move forwards to backwards applying
light pressure with a constant rhythm. This way the
work piece does not get too hot, will not discolor and
there will not be rough edges.
• Cutting:
Do not press, tilt or oscillate the tool. Work at a
moderate speed. The disc should always rotate
counterclockwise since there is a risk the tool shoots
out uncontrolled.
To cut hard stones using a diamond cutting disc is
recommended.
Useful tips
• Work placing the disc in the right position to prevent damage.
• Press the work piece applying pressure lower than the tool's weight to prevent
overload damaging the motor and the disc.
• After installing a new disc allow it to run unloaded at least one minute. If
vibration occurs replace immediately.
CAUTION
• Avoid working on wood or soft metals like lead. These
materials saturate the disc very quickly making it useless.
8
ENGLISH
Preparation
Start Up

Publicidad

loading

Este manual también es adecuado para:

13870