Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTIONS, OPERATING AND DISPLAY ELEMENTS
12
MIC INPUT
1
Balanced microphone input (XLR/6.3 mm jack combo). The use of an unbalanced microphone cable (mono jack) is also possible. The microphone
input has a built-in 100 Hz noise filter to suppress any unpleasant low-frequency signal artefacts. PLEASE NOTE: There is no phantom power on the
microphone input.
HI-Z INPUT
2
High-impedance mono input with 6.3 mm jack socket for an electro-acoustic or electric guitar.
MP3
3
Stereo line input with 3.5 mm jack socket for an MP3 player or other playback device. The two interfaces for MP3 and Bluetooth can be used simulta-
neously. The volume ratio must be set on the playback devices. When using a single MAUI5 GO (100) system, activate the mono preset (see point 14).
BLUETOOTH
/MP3
4
®
Volume control for the Bluetooth module or MP3 input. Rotate to the left to decrease and to the right to increase the volume. The two inputs for
MP3 and Bluetooth can be used simultaneously. The volume ratio must be set on the playback devices.
HI-Z
5
Volume control for the HI-Z input. Rotate to the left to decrease and to the right to increase the volume.
LINE
6
Volume control for the line channel (line inputs on the back of the subwoofer). Rotate to the left to decrease and to the right to increase the
volume.
MIC
7
Volume control for the microphone channel. Rotate to the left to decrease and to the right to increase the volume.
HI-BOOST
8
High shelf-filter for fine-tuning the high-frequency response to suit the room acoustics (rotate all the way to the left [1] for a neutral sound, and
rotate to the right to increase the highs).
SUB LEVEL
9
Setting the volume balance between the subwoofer and the column loudspeakers.
8
4
5
3
2
13
9
8
6
7
1
14
10
11
Publicidad
