ACCESSORIES AND REQUIRED TOOLS
Make sure the following accessories are included with your refigerator :
Hex wrench
Required Tools (Not provided)
You need the following tools to complete the installation of your refirgerator:
Philips screwdriver(+)
REMOVING THE REFRIGERATOR DOORS
Some installations require door removal to transport the refrigerator to its final location.
Do not remove the door/drawer if you don't need to. If you do not need to remove the refrigerator doors, go to
adjusting the level. If you need to remove the doors. continue below. Before removing the door/drawer make
sure you read following items :
Disconnect power to the refrigerator before removing the door or drawer.
WARNING
• Be careful not to drop, damage or scratch the door/drawer while removing them.
• Be careful not to get injured while removing the door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassemble the refrigerator doors
Be careful not to drop and scratch the doors while
removing the doors.
WARNING
Disassemble the refrigerator doors
1. With the door opened, remove the cap top table (
a flat-blade screwdriver(-), and close the door. Remove
the 3 screws holding down the top table (
over with several wires connected.
DA68-01926A-10.indb 9
Fastener
Flat-blade screwdriver(-)
Socket wrench (10mm)
2
Pliers
) with
1
) and turn it
1
Allen wrench(3/16")
(5mm)
2
Setting Up _9
13. 4. 24.
11:37