Beko GN163232XBN Manual Del Usuario página 76

Using the product
When the ice dispenser does not work
properly
If you do not remove ice cubes for a long time, they
will cause formation of ice chunks. In this case, please
remove the ice stock reservoir in accordance with the
instructions given above, seperate the ice chunks,
discard the inseparable ice and put the ice cubes back
into the ice stock reservoir. (Figure 4)
When ice does not come out, check for any ice stuck
in the canal and remove it. Regularly check the ice
canal to clear the obstacles as shown in the figure 5.
When using your refrigerator for the first time or when not
using it for an extended period of time Ice cubes may be
small due to air in the pipe after connection, any air will be
purged during normal use.
Discard the ice produced for approximately one day since
the water pipe may contain the contaminants.
Caution!
Do not insert the hand or any other object into the ice canal
and blade since it may damage the parts or hurt the hand.
Do not let the children hang on the ice dispenser or the ice
maker since it may cause an injury
To prevent dropping the ice stock reservoir use both hands
when removing it.
If you close the door hard, it may cause water spilling over
the ice stock reservoir.
Do not dismount the ice stock reservoir unless it is
necessary.
If there is a lockout (ice does not come from
the refrigerator) while taking broken ice, try
to take cubed ice.
Then it will be suitable for taking broken ice
again.
While taking broken Ice, cubed ice may
come first. There is a case of coming cubed
ice while taking broken ice.
Freezer door on front of the ice machine can
create a light snow and film layer.
This is normal, it is recommended to clean
without waiting for a long time.
The water is filled with water over time in
the lower zone of the water dispenser. It
is recommended to clean the water within
this zone periodically.
While the ice falls from the ice storage
reservoir, the sound is normal and does not
indicate that the product is problematic.
The blade mechanism inside the ice bank is
sharp and can cut your hand.
If the ice dispenser does not provide ice, the
ice may be stuck together, remove the tank
and clean it again.
Ice type cannot be changed on the display when the ice
trigger is pressed to obtain ice. Release the trigger, change
the ice type on the display and obtain ice again.
34 / 38 EN
Refrigerator / User Guide