MIRKA DEOS 343 Instrucciones De Manejo página 56

en (original)
The speed can be adjusted between 5,000 rpm and max by adjusting the position of the lever.
The max rpm can be adjusted by pressing rpm+ or rpm , Figure 1. The rpm can be adjusted in steps 5 000, 6 000, 7 000,
7 500, 8 000, 9 000 and 10 000 rpm.
The tool has two speed control modes. In the default mode the speed can be adjusted linearly by changing the position
of the lever. In the other mode the speed remains fixed at the set max rpm when the tool is running. When the rpm+
and rpm buttons are pressed simultaneously the tool toggles between the two controlling modes.
When sanding, always place the tool on the work surface before starting the tool. Always remove the tool from the
work surface before stopping it.
When sanding is finished, turn off the sander by pressing the On/Off key. The sander LED (right) is now turned off.
Bluetooth
This tool is equipped with Bluetooth® low energy technology and can be connected to an app from which additional
tool functionality can be accessed. For more information on the app functionality and if it is available in your country, go
to www.mirka.com/mymirka
Activate Bluetooth on your Mirka
1. Connect the power cord to mains outlet.
2. Press and hold the Speed+ button while switching the tool on with the On/Off button.
Left LED lights up (green), to indicate that Bluetooth is active.
3.
Bluetooth is deactivated when the tool is disconnected from mains outlet.
4.
NOTE! If the app is not installed or if it is not available in your country, Bluetooth shall not be activated.
®
The Bluetooth word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such
marks by Mirka Ltd is under license. Other trademarks and trade names are those of their respective owners.
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad
A = 8 mm (only on 70 × 198 mm)
B = 16 mm
56
Mirka® DEOS 343, 353, 383 & 663
®
DEOS as follows: