Caso WK 2100 Manual Del Usuario página 35

 Mesh
 The mesh is located it the sprout of the pot. Pull it up and wash it under running water.
Then place the mesh back correctly.
Base

 The stainless steel surface of the base can be cleaned with a commercial stainless steel
cleaning agent.
 Buttons
 Clean the buttons with a damp cloth. Do not use cleaning agents.
16.7 Descaling
 Depending on the hardness of water you should descale the device once every two
weeks.
 Fill the pot with water and a commercial descaler or give a sip of vinegar into the water.
Heat the mixture to 70 °C but do not boil it to prevent overcooking. Rinse the pot with
fresh water after descaling.
► Regularly decalcifying your WK 2100 compact will reduce the electricity used and
prolong the life of the device.
17 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
Problem
The device switches off before
boiling or before it has
reached desired temperature.
The device does not switch
off.
The device cannot be
switched on.
Please note
Attention
Cause
Too much scale in the
pot.
The lid is not closed
correctly, the mesh is not
inserted correctly.
The device has not
cooled down sufficiently.
Solution
Descale the device.
Close the lid correctly. Place
the mesh into device
correctly.
Allow the device to cool
down.
35