Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Possible cause
The surface unit
The element will cycle on
frequently cycles
and off to maintain the
on and off.
power setting.
The surface unit
This is normal. The unit is still on and hot.
stops glowing when
changed to a lower
setting.
Scratches or
The cooktop is being
abrasions on the
cleaned improperly.
cooktop surface.
Cookware with rough
bottoms was used on the
cooktop or there were
coarse particles (e.g., salt or
sand) present between the
cookware and the surface
of the cooktop.
Cookware has been slid
across the cooktop surface.
Solution
This is normal operation,
Brown streaks or
and not a system failure.
specks.
Use the range as usual.
Scratches are not
removable. Tiny scratches
will become less visible in
time as a result of cleaning.
Areas of
Use ceramic glass top
discoloration with
cleaning cream. Do not
metallic sheen.
use chemical or corrosive
agents. These agents may
damage the surface of the
product.
To avoid scratches, follow
the recommended cleaning
procedures. Make sure
"Cracking" or
cookware bottoms are
"popping" sound.
clean before use, and use
cookware with smooth
bottoms.
Problem
Possible cause
Boilovers have been cooked
onto the surface.
Mineral deposits from
water and food have been
left on the surface of the
cooktop.
This is the sound of the
metal heating and cooling
during both the cooking
and self-cleaning functions.
Solution
Wait until the surface
•
cools down. Then,
use a single-edge
razor-blade scraper at
approximately a 45°
angle against the glass
surface to remove the
soil.
•
See the section on the
care and cleaning of
the glass cooktop on
page 55.
•
Remove using a
ceramic-glass cooktop
cleaning cream.
•
Use cookware with
clean, dry bottoms.
Clean the cooktop with
a ceramic cleaning
agent regularly every
week.
This is normal operation,
and not a system failure.
Use the range as usual.
English 61
Publicidad
