Publicidad
Idiomas disponibles
Idiomas disponibles
Installation of the Water Pipe Supply Joint
Hex Wrench H12
(1) Wrap the threads of the water pipe supply joint with Te on tape or other seal tape;
(2) Tighten the water pipe supply joint into the supply line elbow with the hex wrench.
Installation of the Escutcheon
Set Screw
(Figure 3)
(3) Put the escutcheon onto the shaft gland.
(4) For convenient installation, loosen the 4 pre-mounted screws until shaft gland is
ush with the wall surface. Do not remove all screws to avoid interfering with the
water supply joint, which may lead to installation failure
(as shown in Figure 4).
INSTALLATION PROCEDURE
Wall Surface
Water Pipe
Supply Joint
Fastening Screw
Shaft Gland
Escutcheon
4
1/2" NPT
Hex Wrench H12
Not required to remove all 4
screws, but it is necessary to
loosen the screws until shaft
gland is ush with wall surface.
(Figure 4)
Supply Line Elbow
(Figure 2)
Publicidad
