Publicidad
Idiomas disponibles
Idiomas disponibles
Body Spray Installation
Body
Hex Wrench H12
Spray
Water Pipe
Supply Joint
(Figure 5)
(5) Put the shower body spray in the water pipe supply joint, and tighten the 4 screws
(3 fastening screws and 1 set screw) on the shaft gland; and face TOTO up while
installing (as shown in Figure 5 and Figure 6)
Fastening of the Escutcheon
Wall Surface
(Figure 7)
(6) Place the escutcheon close to the nished wall surface, and use the hex wrench to
tighten the screw located at the bottom of the escutcheon (as shown in Figure 8)
INSTALLATION PROCEDURE
1/2" NPT
Wall Surface
Escutcheon
(Figure 6)
Wall Surface
(Figure 8)
5
Face TOTO Up
Tighten Screws
Publicidad
