Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
Placement
•
Place the automatic coffee maker on a stable and level
surface. Place the appliance in such way that it cannot tip
over.
•
Do not place the appliance in close proximity to a gas or
electric stove or any other heat source.
Electric Connection
NOTE:
Make sure the device is switched off. The switch must be
at the "0" position.
1. Ensure that your mains power corresponds with the specifi-
cations of the appliance. The specifications are printed on
the type label.
2. Connect the mains cable to a properly installed and earthed
wall outlet.
Operation
Before making coffee for the first time operate the appliance
twice with clean water only and without paper filter. This re-
moves dust, which may have collected during transport. Follow
the instructions given under "Operation".
Operation
1. Open the lid of the water tank.
2. Fill cold water according to the desired amount of cups of
coffee into the rear water tank. The water level is displayed
on the indicator.
NOTE:
You can use the pot to fill the water tank.
CAUTION:
Do not overfill the tank! Do not fill it above the MAX mark.
3. Ensure that the filter holder is properly attached.
4. Turn over the lower fold of the paper filter (size 1x4) and
place it in the filter funnel. Then fill it with coffee powder.
5. Now close the lid of the water tank.
6. Place the jug onto the warming plate.
CAUTIION: Drip stop
Your appliance comes with a drip stop. It closes when
removing the coffee pot. This prevents the coffee from
dripping onto the warming plate if there is still water in the
filter.
•
Ensure that the lid is attached to the coffee pot. It
opens the drip stop.
•
If there is still water in the tank, place the pot under-
neath as soon as possible. Otherwise the filter might
overflow.
7. Switch on the device. The indicator lamp in the switch will
light up.
The Coffee Is Ready
NOTE:
The brewing process lasts approximately. 8-12 minutes.
•
When no more coffee is flowing through the filter you can
remove the pot.
•
Turn the device off.
•
Would you like to keep the remaining coffee warm? Leave
the machine switched on until the pot is empty.
NOTE:
The filter holder can be removed from the machine by its
handle. This makes it easier to dispose of the old coffee filter,
for example.
WARNING:
If you want to make another pot of coffee immediately, switch
off the device first. Let it cool down with the water tank open
in order to avoid hot water splashing when refilling with water.
De-scaling
De-scaling is necessary when the brewing time increases
substantially.
•
Use only commercially available citrus acidbased de-scaler.
•
Follow the recommended instructions for use.
WARNING:
•
Afterwards you should boil fresh water in the pot three or
four times in order to rinse out residues of the descaling
agent.
•
Do not use any coffee powder!
Do not use this water for consumption.
•
Cleaning
WARNING:
•
Before cleaning, always remove the mains plug and wait
until the device has cooled down.
•
Do not immerse the device in water. Otherwise this might
result in an electric shock or fire.
CAUTIION:
•
Do not use a wire brush or any abrasive items.
•
Do not use any acidic or abrasive detergents.
•
The exterior of the device should be cleaned as necessary
with a slightly damp cloth – without any additives.
•
Remove spilled coffee grounds with a paper towel from the
inner casing. Afterwards wipe with a damp cloth.
•
The coffee pot and the filter pad should be cleaned by rins-
ing in warm water. Use a soft brush if necessary.
29
Publicidad
