Pump Maintenance - Troy-Bilt 020210 Manual Del Operario

Section 5: Maintenance

Pump Maintenance

Changing Pump Oil
Change oil after first 50 hours of operation and then every
200 hours or 3 months, whichever occurs first.
NOTE: When changing pump oil, use only high quality
nondetergent 30 weight oil. Use no special additives.
Change pump oil as follows:
1. Clean area around brass oil drain plug at bottom of
pump.
2. Remove oil drain plug. Drain oil completely into an
approved container.
3. When oil has completely drained, install oil drain plug
and tighten firmly.
4. Clean area around pump oil dipstick. Remove dipstick
and fill pump with recommended oil to "Full" mark on
dipstick (typically 0.43L or 15 oz.).
5. Install pump oil dipstick.
6. Wipe up any spilled oil.
Data Tag
Data tag information is very important if you need help from
our Customer Service Department or an authorized service
dealer.
• The data tag (Figure 15) is located on the base of the
pressure washer. For future reference, please copy the
model, revision, and serial number of the pressure washer
in the space below.
Figure 15 — Data Tag
MODEL
REV NO
SERIAL
PSI
GPM
16
Copy Model
Number Here
Copy Revision
Here
Copy Serial
Number Here