Pump Maintenance - Troy-Bilt 020287 Manual Del Operario

Section 5: Maintenance
Pump Maintenance
Changing Pump Oil
Change oil after first 50 hours of operation and then every
200 hours or 3 months, whichever occurs first.
NOTE:When changing pump oil, use only high quality
nondetergent 30 weight oil. Use no spedal additives.
Change pump oil as follows:
[. Clean area around brass oil drain plug at bottom of
pump.
2. Remove oil drain plug. Drain oil completely into an
approved container.
3. When oil has completely drained, install oil drain plug
and tighten firm[),.
4. Clean area around pump oil dipstick. Remove dipstick
and fill pump with recommended oil to "Full" marl< on
dipstick (typically 0.43L or 15 oz.).
5. Install pump oil dipstick.
6. Wipe up any spilled oil
D ata Tag
Data tag information is very important ff you need help from
our Customer Service Department or an authorized service
dealer.
• The data tag (Figure 16) is located on the base of the
pressure washer. For future reference, please copy the
mode[, revision, and serial number of the pressure washer
in the space below.
MODEL [ ]4_
REV N O[ 1_
SER,AL [ 1_
Ps, [ i
GPM [ i
O TRO_RM-T'_
_,_ Copy Model
Number Here
_Copy Revision
Here
Copy Serial
Number Here
O