Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning metal grease filters
The filters must be cleaned every 2 months of opera-
tion, or more frequently for particularly heavy usage,
and can be washed in a dishwasher.The metal grease
filters should be cleaned frequently in hot detergent
solution or washed in the dishwasher. Stainless steel
cleaner should be used on stainless rangehoods.
Abrasives and scouring agents can scratch stain-
less steel finishes and should not be used to clean
finished surface. Remove all water or any other liquid
from washing before re-installing filters.
• Remove the filters one at a time, supporting
them with one hand and turning the safety
knobs (pull and turn).
• Wash the filters, taking care not to bend them.
Allow them to dry before refitting.
• Replace them and fix them using the safety
knobs provided (pull and turn).
• No water can be present in filters before install-
ing back in hood.
Replacing Activated Charcoal Filter
The filter is not washable and cannot be regenerated,
and must be replaced approximately every 4 months of
operation, or more frequently for particularly heavy usage.
• Remove the Filters one at a time, pushing them
towards the back of the unit and at the same time
pulling downward.
• Remove the saturated charcoal filter by releasing the
fixing hooks.
• Fit the new filter and fasten it in its correct position.
• Replace, taking care to ensure that the handle faces
forwards.
• CAUTION: When used in recirculation mode, to Re-
duce the Risk of Fire and Shock use only conversion
kit Model FILTER2.
Lighting unit
• Remove the snap-on lamp cover
by levering it from under the metal
ring, supporting it with one hand.
• Replace the lamp with a new one
of the same type, making sure that
you insert the two pins properly into
the housings on the lamp holder.
• Replace the snap-on lamp cover.
Gu10 self-ballasted led
lamps – listed in ac-
cordance with
ul 1993/nmx-
j-578/1-ance/
csa c22.2 No.
1993
15
Publicidad
