Publicidad
Idiomas disponibles
Idiomas disponibles
•
It is easier and more efficient to remove snow
immediately after it falls.
•
Always throw snow downwind whenever
possible.
•
On flat surfaces, like asphalt roads, raise the skid
plates up to 5-6 mm (0.2-0.25 in) off the ground.
•
The scraper bar is reversible. When it becomes
worn almost to the edge of the housing, reverse
Introduction
When the product is in use, bolts can loosen and
components can become worn. This can cause
Maintenance schedule
Maintenance
Make sure that nuts
and screws are
tightened
Do a check of the
engine oil level
1
Replace oil
Make sure there are
no fuel or oil leaks
Remove clogging,
foreign objects in
auger
Inspect the tire
2
pressure
Inspect and change
3
the spark plug
Note: It is not necessary to add grease or to do other
maintenance to the gearbox.
To do a general inspection
•
Make sure that the nuts and screws on the
product are tightened.
To do a check of the oil level
CAUTION: A too low oil level can do
damage to the engine. Do a check of the
oil level before you start the product.
1. Put the product on level ground.
1
Replace the oil after the first 20 h, 50 h, 100 h and then every 100 h.
2
See Technical data for correct tire pressure.
3
Check and clean spark plug before use each year.
14
Maintenance
Daily
20 hours
X
X
X
X
it. Replace the scraper bar if it is damaged, or if
both sides are worn.
•
Do not dispatch the chute deflector if it is
clogged.
•
If the product does not move forward due to
unforeseen circumstances, release the drive
engagement immediately or pull out the ON/OFF
key to OFF position.
malfunction like incorrect tolerance clearance,
increased oil consumption, or misalignment of
various components. Do regular maintenance on the
product to prevent malfunction.
50 hours
X
X
X
2. Remove the oil tank cap with the attached
dipstick.
3. Clean the oil from the dipstick.
4. Put the dipstick fully into the oil tank to give a
correct picture of the oil level.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again.
To replace the engine oil
1. Run the engine a few minutes to make the oil
warm. Warm oil flows better and includes more
contaminants.
100 hours
X
X
791 - 002 - 08.01.2020
Publicidad
