RedMax DST24 Manual Del Usuario página 9

3. Install more carriage bolts (D) and handle knobs
(C) to secure the upper handle (A) to the lower
handle (E).
A
D
E
To install the chute deflector and
chute rotator head
1. Put the chute deflector assembly on top of the
chute base with the discharge opening to the
front of the product.
2. Put the chute rotator head (A) on the chute
bracket (B). If necessary, turn the chute
assembly to align the pins under the chute
rotator head with the holes in the chute bracket.
3. Put the chute rotator head on the pin (C) and the
threaded stud (D) of the mounting bracket (E).
4. Attach a locknut (F) on the threaded stud and
tighten.
791 - 002 - 08.01.2020
C
5. Attach the rotator cable (H) to the lower handle
with the double clip (G).
To install the chute deflector remote
control
1. Attach the remote cable bracket (A) to the
discharge chute with a carriage bolt (B) and a
5/16-18 locknut (D). Tighten the bolt.
2. Install the remote cable eyelet (E) to the chute
deflector (F) with a shoulder bolt (G), a nylon
washer (C), and tighten with a ¼-20 locknut (K).
The cable eyelet will be loose on the shoulder
bolt.
3. Attach the spring (L) between the hex nut (M) on
the chute rotator head and the hole on the chute
deflector.
A F
B
G
H
E D C
H
9