Publicidad
Idiomas disponibles
Idiomas disponibles
2. Remove the wooden block from below the
product.
3. Lift the handle to tilt the rear section up. The front
section will tilt back and pivot to attach the rear
section.
4. Make sure that the belt is put in the auger pulley
groove correctly.
5. Install the 5/16'' bolts (A), (C) and tighten (8-12
Ft.Lbs / 11-16 Nm).
6. Install the ¼'' bolts (B) and tighten (4-6 Ft.Lbs /
5-8 Nm).
7. Install the auger belt on the engine pulley. Make
sure that the belt is put correctly around the idler
791 - 002 - 08.01.2020
A
C
B
pulley and installed correctly in the engine pulley
groove.
8. Operate all controls to make sure that the auger
belt is installed correctly and that all components
are moving correctly.
To remove the wheels
1. Remove the wheel pin (A) and the retainer pin
(B).
2. Remove the wheel from the axle (C).
A
B
To clean the product
•
Clean plastic parts with a clean and dry cloth.
•
Do not use a high pressure washer to clean the
product.
•
Do not flush water directly on the motor.
•
Use a brush to remove leaves, grass and dirt.
C
19
Publicidad
