Publicidad
Step 18
Insert the non-threaded end of the LONG SUPPORT ROD (24A) through the RIGHT
å
UPRIGHT (C2) and into an ANCHOR PLATE (66G).
Thread the TURNBUCKLE (9A) onto the threaded end of the LONG SUPPORT ROD (24A).
å
Place the SPACERS (22A) under the SUPPORT RODS (23A and 24A) with the RODS
å
resting in the grooves of the SPACERS.
Hand tighten the TURNBUCKLE (9A) until it is snug. The SPACERS will be tightened
å
between the SUPPORT RODS and the TOP. Now, insert your screwdriver through the large
hole in the middle of the TURNBUCKLE and turn the TURNBUCKLE another half turn.
NOTE: Tighten the TURNBUCKLE if the TOP ever begins to sag.
å
66G
24A
www.sauder.com/services
C2
24A
22A
9A
23A
22A
418656
Page 23
Publicidad
