Black and Decker KG65 Manual De Instrucciones página 23

HANDY HINTS
• Always position the guard so that as much of the
exposed disc as possible is pointing away from you.
• Be prepared for a stream of sparks when the disc
touches the metal.
15°
of the disc and avoids unnecessary overloading.
All manuals and user guides at all-guides.com
disc on the
OVERLOAD
backing pad.
Overloading will cause damage to the motor of your
Fit the threaded
angle grinder. This can happen if your angle grinder is
outer flange and
subjected to heavy duty use for prolonged periods of
tighten as
use. Do not in any circumstances, attempt to exert too
explained in
much pressure on your angle grinder to speed up your
'Fitting the discs'.
work. The abrasive discs operate more efficiently
when a light pressure is exerted, thus avoiding a drop
in the speed of your angle grinder (see Tool care).
TOOL CARE
Keep guards, air vents and the motor housing as clear
as possible of dust and dirt. Wipe with a clean cloth
and blow through with a low-pressure air supply.
Excessive build-up of metal dust can cause tracking of
electrical current from the internal parts to exposed
metal parts. Do not overload your angle grinder.
Overloading causes a reduction in speed and
efficiency, causing your angle grinder to become too
hot. If this happens, operate your angle grinder under
no load for one or two minutes until it has cooled to
normal operating temperature. Switching your angle
grinder off under load will reduce the life of the switch.
CLEANING
Use only mild soap and a slightly damp cloth to clean
your angle grinder. Many household cleaners contain
chemicals which could seriously damage the plastic.
Hold your angle
Also, do not use petrol, turpentine, lacquer or paint
grinder firmly with
thinners or similar products. Never let any liquid get
one hand around
inside the tool and never immerse any part of the tool
the side handle
into liquid.
and the other
around the body
EC DECLARATION OF CONFORMITY
of your angle
We declare that units: KG65, KG72, KG90 conform to
grinder.
89/392/EEC, 89/336/EEC, EN55014, 73/23/EEC, EN55104,
EN50144, HD400, EN61000
A weighted sound pressure 97.7dB (A)
A weighted sound power 110.7dB (A)
Hand/arm weighted vibration <2.5m/s
When grinding,
always maintain
Brian Cooke - Director of Engineering
the correct angle
Black & Decker Ltd, Spennymoor, County Durham
between the disc
DL16 6JG United Kingdom
and the work
The Black & Decker policy is one of continuous
surface (15˚).
improvement to our product and as such we reserve
This increases the
the right to change the product specification without
removal capacity
prior notice.
ENGLISH
2
23