Publicidad
Idiomas disponibles
Idiomas disponibles
ZGR OPTIME
Back panel:
ZGR STEADY 1000 back panel
RS232 port for monitoring
USB port for monitoring
RJ45 overvoltage protection
3.
Package content
Within the package you should have received the following items:
- UPS equipment
- Fast guide
- Input (1 unit) and Output (2 units) cables
- USB communication cable
- Monitoring software register card
4.
Inspection
Remove the UPS from its packaging and inspect it for damage that may have occurred during shipping. If any
damage is discovered, repack the unit and return it to the place of purchase.
5.
Charging
This unit is shipped from the factory with its internal battery fully charged, however, some charge may be lost
during shipping and the battery should be recharged prior to use. Turn on the UPS, plug the unit into an
appropriate power supply and allow the UPS to charge fully by leaving it plugged in for at least 6 hours with no
load (no electrical devices such as computers, monitors, etc.) connected.
6.
Placement
Install the UPS unit in any protected environment that provides adequate airflow around the unit, and is free from
excessive dust, corrosive fumes and conductive contaminants. Do not operate your UPS in an environment where
the ambient temperature or humidity is high.
QUICK GUIDE
ZGR STEADY 1500/2000 back panel
Input socket
Input fuse
Output socket
Publicidad
