Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Keypad overview (fig. III)
1 On / Off
2 Volume / operating mode
3 LED accuracy / activation
Display overview (fig. IV)
1 "Rotating laser" mode
2 "Line laser" mode
3 Acoustic signal: loud
4 Acoustic signal: quiet (default)
5 Acoustic signal: off
6 Battery low
7 Battery OK
8 Accuracy of readings: Coarse, ± 3 mm
9 Accuracy of readings: Medium, ± 2 mm
(default)
10 Accuracy of readings: Fine, ±1 mm
Switching the device on / off
Press the on / off button [1].
■
Adjusting the volume
Press the button [2] once briefly.
■
3 Acoustic signal: loud
Press the button [2] twice briefly.
■
3 Acoustic signal: off
Selecting the operating mode
Press the button [2] for >3 seconds.
■
3 Switches from rotating laser to line laser and
vice versa.
Adjusting the accuracy of readings
Press the button [3] once briefly.
■
3 Accuracy of readings: coarse
Press the button [3] twice briefly.
■
3 Accuracy of readings: fine
Activating the LEDs
Press the button [3] for >3 seconds.
■
Operation
Hold the device vertically (in case of a vertical
■
laser plane: horizontally) and move towards the
laser plane.
Please pay attention to acoustic signals and
■
arrows on the (LED) display.
Display overview (fig. IV)
Signs on the display
11
No laser
12
Much too low
13
Too low
14
Height OK
15
Too high
16
Much too high
Note
When you switch your device on, it is in
the operation mode used before it was
switched off.
• If in line laser mode, the device detects only
the line laser type that has been detected
immediately after switching on.
• When switching on the device for the first
time, it runs in rotating laser mode.
Maintenance / Care
Keep the device always clean, especially
the receiver field!
Do not use aggressive cleaning agents or
■
solvents.
If soiled heavily the device can be cleaned
■
under running water.
Do not immerse your appliance in water.
■
Do not use high-pressure cleaner.
■
Allow it to dry completely before storing it in a
■
closed container.
• Residual moisture can result in corrosion of
the battery contacts. In this case our warranty
expires.
In the unlikely event of a failure or defect, have
■
the appliance examined and repaired by an
authorised customer service point for Würth
power tools.
In all your queries and spare part orders,
■
always quote the 10-digit product number (see
type plate) of your device.
Acoustic signals
None
Signal in short intervals
Signal in short intervals
Continuous signal
Signal in long intervals
Signal in long intervals
11
Publicidad
