Installation - Truper BOS-1/2LPX Manual De Instrucciones

Installation

B
WARNING • Do not touch the power plug with wet hands. Always disconnect the plug and do not pull
off the power cable. Do not use the power cable to lift, carry or hold the pump in any way. Do not use the cable
for uses different to the specified use. Do not pull the cable while the pump is running. It can get damaged and
cause an electric shock.
CAUTION
C pump, cable and plug are not showing any damage due
to transportation and storage.
• Connect the hose to the water outlet (hose adapter A).
Use a clamp to fasten the soft hoses and a soldered
flange for steel hoses.
• To submerge the pump tie one end of rope onto the
transportation handle (B).
• Hold the rope for submerge the pump.
CAUTION
float switch to carry or hang the pump.
• Tie the other end of the rope to some fixed point to
support the pump no more that 16,4' below the water
surface and no less that 20" from the bottom to prevent
mud, particles, algae or residue to block the pump.
• Double check there are no obstacles so that the float
switch can move freely (C).
A
• Before installing double check the
• Never use the power cable or the
ENGLISH
7