Parts - Truper BOS-1/2LPX Manual De Instrucciones

CAUTION • The connection source shall come from
properly installed and tested grounded outlets. Power from
the power supply and fuse shall match the pump's
technical data.
CAUTION
• The pump shall be connected through
an RCCB (residual current breaker) with short circuit
current design not greater to 30 mA
CAUTION • Before connecting double check the
power supply matches the pump's requirements.
CAUTION • The pump shall be used only within the
rated voltage, potency and rotation speed (see the
manufacturer's nameplate).
WARNING • Do not entangle, tighten or run-over
the power cable. Protect it from sharp edges, oil or heat.
CAUTION • Do not use extension cables with a
lower gauge than the power cable gauge.
Rope
6
ENGLISH
Transportation
Handle
Power
Cord
Suction
Base
Safety Warnings for
Submersible Pumps
WARNING • In the event the power cable is
damaged, disconnect the pump from the power supply
immediately! Never run a pump if the power cable is
damaged.
WARNING • Disconnect the plug from the power
supply before removing the pump from the water or
when servicing.
CAUTION • Disconnect the pump when not in use.
• Before connecting the pump to the
CAUTION
power supply double check the float switch is set in the
OFF position.
CAUTION • Before disconnecting the pump, the
float switch shall be set in the OFF position.
• Do not install nor connect the pump if
WARNING
there are people or animals in the liquids to be pumped.

Parts

Float
Switch
(Hose Adapter)
Water Outlet