Start Up; Maintenance - Truper BOS-1/2LPX Manual De Instrucciones

Float switch
• The float switch goes On and OFF automatically,
depending on the water's level height. When the float
switch is placed into the same height as the transport
handle, the pump starts; and when it goes down to
approximately 4", it turns it off.
• To control the float switch manually and prevent the
pump to automatically shut off, you can set the switch
cable through the transport handle (D) so that the float
cannot plunge down and shut off the pump.
CAUTION • When controlling the float switch
manually do not stop supervising the pump's functioning.
Prevent the water level to be so low it will make the pump
operating dry.
Cleansing and Care
• Inspect regularly all the mounting screws and double
check the screws are correctly tightened. In the event one
of the screws is loose, tighten immediately.
Turbine Cleansing
• In case there is contamination inside the pump, the suction
base can be removed unscrewing the pan head screw fixing
it to the pump's body. This way you clean the turbine. For
safety reasons a damaged turbine can only be replaced in a
Authorized Service Center.
8
ENGLISH
Float Switch in
automatic shut off position

Start up

WARNING • Avoid the pump operating dry, otherwise it
can break down. When the water stops flowing, disconnect the
pump immediately.
• The motor thermal protector shuts off the pump
automatically in the event of overheating. In order for the
pump to work again, it will be necessary:
1. Give it a cooling period of approximately 30 min.
2. You must unplug the plug from the outlet and reconnect, so
that the thermal protector can be demagnetized. NOTE: If the
pump shuts down again, please contact a Truper Authorized
Service Center.
• After pumping chlorinated water from a swimming pool or
another liquid with residues, you need to rinse the pump with
clear water.
• The submergible pump is equipped with a ventilation valve
to prevent pressure leaking into the pump. Water entering
through the valve can happen but is not a defect.
Float Switch in
manual shut off position

Maintenance

Storage
• If frost is expected, store the pump in a dry place
protected against frost. Otherwise the pump may be
damaged.
Service
• Servicing tools can only be carried out in a
Authorized Service Center.
Maintenance service carried out by non-qualified people
can turn dangerous and cause personal injury. Also, it
makes the Warranty void.
D