Descargar Imprimir esta página

Black and Decker BDH2000SL Manual De Instrucciones página 6

Ocultar thumbs Ver también para BDH2000SL:

Publicidad

Idiomas disponibles

Idiomas disponibles

4. The battery pack should be recharged when it fails to produce sufficient power on
jobs which were easily done previously. DO nOT COnTInUE to use under these
conditions. Follow the charging procedure. You may also charge a partially used pack
whenever you desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to, steel wool,
aluminum foil, or any buildup of metallic particles should be kept away from charger
cavities. Always unplug the charger from the power supply when there is no battery
pack in the cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING:
attempt to open the battery pack for any reason. If the plastic housing of the battery
pack breaks or cracks, return to a service center for recycling.
INSTALLING AND REMOVING THE BATTERY
WARNING:
TO InSTALL BATTERy PACk: Insert battery pack into the
vac until an audible click is heard (Figure C). Make sure
battery pack is fully seated and fully latched into position.
TO REMOVE BATTERy PACk: Depress the battery release
button (6) as shown in Figure C and pull battery pack out of the vac.
OPERATIOn
fIGURE D
nOTE: THIS PRODUCT IS fOR DRy PICk-UP OnLy.
• To switch the vac on, slide the on/off switch forward.
• To switch the vac off, slide the on/off switch back.
ASSEMBLy
fIGURE E
Remove the dust bowl by pressing the dust bowl release
button and pulling the bowl down and out.
• Remove the filter by pulling it out of the dust bowl.
• Install the filter into the dust bowl by aligning the filter
triangle with the dust bowl triangle and placing it firmly into
position as shown in figure f.
nOTE:
It is very important that the filter is correctly in
position before use.
• To install the dust bowl, place it back onto the front of the unit
and click firmly into position.
MOUnTInG ACCESSORIES
• The brush tool (9) has a brush that can be used for
dusting and upholstery cleaning.
• The crevice tool (8) allows for vacuuming in narrow and
hard to-reach places.
• To attach an accessory, press the accessory into dust bowl.
• To remove an accessory, pull the accessory out of the dust bowl.
CLEAnInG THE PRODUCT
WARNING:
without its filters.
nOTE:
The filter is re-usable, do not confuse them with
disposable dust bags, and do not throw it away when the product is emptied. We
recommend that you replace the filter every 6-9 months.
IMPORTAnT:
an empty dust bowl. If dust begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
• Remove the filter and shake or lightly brush any loose dust off the filter.
Empty the dust from the bowl and wash if necessary.
• Wash the filter regularly using warm, soapy water as shown in figure G. Ensure that it is
completely dry before using again.
Shock hazard. Do not allow any liquid to get inside charger. Never
Make certain the vac is switched off before removing or installing battery.
Never use this cordless hand vacuum
Maximum dust collection will only be obtained with clean filters and
6
C
D
E
F

Publicidad

loading